Level 3
Phased Array Ultrasonic Testing
Name Of Tutor
A highly practical course with relevant theoretical background enabling students to achieve a basic understanding of ultrasonic inspection. On completion of the course candidates will be able to calibrate a flaw detector with both compression and shear wave probes, record accurate thickness measurements and locate and size lamination in steel plate. In addition, students will be able to select the correct compression/shear wave probes for the examination of welded butt joints, locate and size defects and finally produce acceptable reports.
Tutor Name
Add Your Heading Text Here
Course Price
Please contact us
Add Your Heading Text Here
Add Your Heading Text Here
Course Duration - 8 Days
Examination Duration - 2 Days
Examination Duration: 2 Days
This is a guidance course aimed at the PCN requirements for an Ultrasonic Phased Array Practitioner Level 3 multi sector, or single sector in one (only) of the following groups: Welds, Castings or Wrought Products.
The main objective is to make candidates fully aware of the scope of the examination and level of knowledge required (This will also enable candidates to identify their weak subject areas). Advice will be given on any further tuition required.
Candidates shall hold both a PCN Level 2 in Phased Array and a PCN Level 3 approval in Ultrasonic Testing. The candidate shall satisfy the experience requirements of PCN/GEN for UT, including 6 months verifiable experience using UT phased array systems before attempting this course.
Level 3 PAUT of general engineering materials, components and fabrications in the pre and inservice inspection multi-sector. Alternatively, Level 3 candidates may apply for single sector certification covering one (only) of the following groups: Castings, Welds, Wrought Products
Special Note
Candidates wishing to participate on a PCN Phased Array (PAUT) Level 3 training course must currently hold a Level 3 certification in Ultrasonic Testing.
Add Your Heading Text Here
Add Your Heading Text Here
Add Your Heading Text Here
Add Your Heading Text Here
Course Content
– PCN requirements for Level 3 approval
– Complementary NDT methods
– Quality assurance, quality control and supervision
– Specifications, procedures and techniques
– Analysis of reports
– Advanced ultrasonic testing theory and revision
– Analysis of procedures
– Procedure writing
– Mock examinations
Add Your Heading Text Here
Add Your Heading Text Here
Add Your Heading Text Here
Other Courses
Add Your Heading Text Here
Add Your Heading Text Here
